You are here

Home » Forums » MotoBikes & MotoAnything » Wrenching » 2006 Yamaha FJR1300 - KrZy8

2021-01-14 KrZy8 Throttle Body Swap Out

dcarver's picture
published by dcarver on Sat, 01/16/2021 - 19:21
Forums: 
2006 Yamaha FJR1300 - KrZy8

 

Here we go again.. runs great then WhamO! Stumbling, will I make it home.. 
And 1 mile later.. GREAT... WTFO?

x 

As found conditions.. routing etc.

Most times, don't complete work in one session... so pics are nice.

Air box removed..

Note to self.. Must remove airbox side funnel before removing from frame...

CC setup...
"

and routing...

FI rail removed.. and what always messes me up.. throttle cables.. I just don't get it.. LOL.

Note to self.. removing pull throttle cable much easier if butterflies stuck open with socket!

Very clean intake ports.. Like this..

x 

x 

x 

x 

New TB, used, but new to me.. 17k miles.

Cleaned up. Most 'dirt' from crankcase vent system.. Why not just vent CC to atmosphere via filter? Just wondering..

New unit ready to rock...

x 

x 

Long day, good night,

Submitted by dcarver on Sun, 01/17/2021 - 10:11.

 

Forgot these pictures...

Replaced the airbox sensor with used eBay unit.

Located here.

LOL, couldn't figure out what this connector went to...

Pics of wire color code so I can look up on schematic.

What the connector looks like.

Where it exits the loom.

Then it hit me! It connects to the airbox sensor! DOH!

 

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer